Message/Author 


Hi there, I have an error message from my EFA output: NO CONVERGENCE. NUMBER OF ITERATIONS EXCEEDED. PROBLEM OCCURRED IN EXPLORATORY FACTOR ANALYSIS WITH 10 FACTOR(S). The User Guide specifies that for this type of convergence problem, I should check to make sure there are no large negative variances / residual variances in the prelim parameter estimates. So for each section of the output (EFA with 2 factors, EFA with 3 factors, etc etc) I have looked at the "estimated residual variances". I don't know what "large" would be. Can you help me understand? Is a residual variance of 0.5 large? 0.6? 0.9? Thank you, KT Tomey 


Please send the output and your license number to support@statmodel.com. 


I get this error message in my EFA: NO CONVERGENCE IN ROTATION ALGORITHM. NUMBER OF ITERATIONS EXCEEDED. PROBLEM OCCURRED IN EXPLORATORY FACTOR ANALYSIS WITH 2 FACTOR(S). THE PROBLEM IS PROBABLY DUE TO THE NEGATIVE RESIDUAL VARIANCE FOR VARIABLE F6. However, when I switch to estimator = bayes,it is performed. Is this correct? 


Bayes keeps residual variances positive through the use of priors. I would consider the onefactor solution. 


But I factor gives me significant chisquare and high RMSEA. What should I do? Should I just keep these values? 


I am sorry, I meant onefactor gives me significant chisquare and high RMSEA... 


You can consider not using that item. If the residual variance is very small and not significant, you would do EFA via ESEM and fix it at zero. 


I tried it so I added in my model command: F BY F1 F2 F3 F4 F5 (*1); (instead of F BY F1 F2 F3 F4 F5;), but I am getting the same results and the same values. What am I doing wrong? 


Please send the output that shows the negative residual variance and your license number to support@statmodel.com. 

DEC posted on Tuesday, May 31, 2016  12:51 pm



Hello, I ran an EFA (1  5) on my data and Mplus conveniently skips the output of the '3 factor model'. I've tried this on various Mplus versions and I'm still getting the same blank result. Can you please help me produce output showing all factor models? Thank you! Daniel 


Please send the output and your license number to support@statmodel.com. 

Back to top 