Message/Author |
|
|
Hi, I ran the model below, but there seems to be an issue that prevents MPLUS from providing fit indices. Any suggestions on how to modify to address this? ANALYSIS: TYPE = GENERAL; ESTIMATOR = MLR; Model: [mi_other] (b0); mi_other ON tao (b1); mi_other ON tatotal (c1); mi_other ON edmd (c2); mi_other ON edmdxta (c3); [tao] (a0); tao ON tatotal (a1); tao ON edmd (a2); tao ON edmdxta (a3); ... Chi-Square Test of Model Fit Value 0.000* Degrees of Freedom 0 P-Value 0.0000 Scaling Correction Factor 1.0000 for MLR RMSEA (Root Mean Square Error Of Approximation) Estimate 0.000 90 Percent C.I. 0.000 0.000 Probability RMSEA <= .05 0.000 CFI/TLI CFI 1.000 TLI 1.000 SRMR (Standardized Root Mean Square Residual) Value 0.000 |
|
|
Your model has zero degrees of freedom so it cannot be tested. In other words, there are no left-out arrows. This is ok. |
|
|
Is there any guidelines for how to report a just-identified model in a published paper, or should I try and adjust the model in some way? |
|
|
You may want to consult with SEMNET. I would just say that the model has df=0 so no overall test of fit is available and just report the effects and their significance. You should not adjust the model to force df>0. |
|
Back to top |