|
|
Multilevel mixture loglinear model |
|
Message/Author |
|
|
Hi, In a multilevel model, "%WITHIN%" AND "%BETWEEN%" sections appear before "MODEL CONSTRAINTS". If a new parameter is specified in "MODEL CONSTRAINT", how can I make it a between level effect? In the example below, (L1_0,L1_11,L2_11) are the actual parameters to be estimated. For some modeling reasons, they can't appear directly in the MODEL section, but have to be reparameterized as a function of some other parameters in the model. If I want some parameters, say L1_11 and L2_11, to vary between clusters, how do I do that? MODEL %WITHIN% %c#1% [x1$1] (t1_1); [x2$1] (t1_2); ... %BETWEEN% MODEL CONSTRAINT: NEW(L1_0 L1_11 L2_11); t1_1=L1_0+L1_11; t1_2=L1_0+L2_11; |
|
|
You would need to use between parameters to define new between parameters. |
|
|
Dear Mplus team, I am wondering if we can run a two-level loglinear model in Mplus. If yes could you please direct me to an example from the user's guide? Thank you in advance. |
|
|
Have a look at the single-level loglinear analysis of ex 7.15 which is based on mixture variables that are observed. Then combine that with the two-level mixture analysis of ex 10.6. |
|
Back to top |
|
|