Poisson versus negative binomial regr... PreviousNext
Mplus Discussion > Categorical Data Modeling >
Message/Author
 Seth J. Schwartz posted on Tuesday, August 13, 2013 - 9:51 am
Linda and Bengt,

How would I know whether to use Poisson or negative binomoial regression for a count variable? And if the variable is zero-inflated, which technique should I choose - zero-inflated Poisson or zero-inflated negative binomial? What effect does my choice have on the results of the analysis?

And what is the Mplus syntax for specifying a variable as negative binomial?

Thanks again for all your help and wisdom!

Seth Schwartz
 Bengt O. Muthen posted on Tuesday, August 13, 2013 - 10:36 am
Use BIC to decide on model. Negbin is specified as

count = y(nb);
 Seth J. Schwartz posted on Tuesday, August 13, 2013 - 11:24 am
Thanks, Bengt! And if it is zero-inflated negative binomial, would the syntax be

count = y(nb) (i);
 Bengt O. Muthen posted on Tuesday, August 13, 2013 - 11:30 am
See the UG on our website, pages 547 - 548 for all the variations.
 Jill Rabinowitz posted on Friday, January 26, 2018 - 10:27 am
Hi,

I am running a negative binomial regression with a continuous DV and a continuous IV. Is there a way to request that mplus provide me with the effect size for each IV? If that's not the case, is there a way that I can calculate the effect size from the mplus output?

Jill
 Bengt O. Muthen posted on Friday, January 26, 2018 - 2:25 pm
It sounds like you are asking for standardized coefficients which are typically not used with count outcomes (although standardizing wrt covariates can be done in Mplus). One common metric to report coefficients in is using incidence rate ratios (Hilbe, p.109), that is, exp(b) where b is the regression slope for a covariate; this can be done in Model Constraint. Hilbe's book is referred to in the UG.
Back to top
Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: