Increase SAVEDATA output PreviousNext
Mplus Discussion > Categorical Data Modeling >
Message/Author
 Arjan Berkeljon posted on Friday, February 11, 2011 - 9:26 am
I am fitting a bifactor model to ordered polytomous data and saving results using the 'SAVEDATA' command. I have noticed that values constrained at zero (e.g. factor correlations) or parameters constrained to be equal lead to reduced SAVEDATA output. That is, values of zero are not written and for multiple constrained parameters only a single value is written instead of the same value for all constrained parameters.

Is there any way to force Mplus to write all values?

Thank you,
Arjan Berkeljon
 Linda K. Muthen posted on Friday, February 11, 2011 - 10:23 am
No, this is related to the fact that the parameter numbering comes from TECH1 where only free parameters get numbers and constrained parameters get only one number.
 Arjan Berkeljon posted on Friday, February 11, 2011 - 1:28 pm
I see. Thank you.
Back to top
Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: