Message/Author |
|
Anonymous posted on Tuesday, December 14, 2004 - 6:53 pm
|
|
|
I've been running a number of CFA models on the same data set using dichotomous indicators and the WLSMV estimator. Models range between 1-3 latent variables. I noticed that following the analysis on a couple of the models the RMSEA was not reported. On the models concerned CFI=1 and TLI>1. Be glad of an explantion for this. Many thanks indeed. |
|
|
I don't know which version of Mplus you are using. I think we now print something for RMSEA in all cases. Could you send the output and data to support@statmodel.com. RMSEA is most likely zero in your case. |
|
|
While a simple CFA model with 4 indcators output from MPlus shows a RMSEA of 0.149 but LISREL is 0.019. Is the definition of RMSEA of MPlus different from that of LISREL. Thanks. |
|
|
Are the estimators the same? Are the chi-square values the same? Are the estimators the same? |
|
|
Does the new version of Mplus provide 90% CIs for the RMSEA when models are estimated with WLSMV? An editor is requesting that we report this information for a paper. Does anyone have a good response to her/his request? Thank you! |
|
|
Yes, Version 6 has 90% confidence intervals for WLSMV. |
|
Erin Kube posted on Tuesday, March 18, 2014 - 12:52 pm
|
|
|
Is there a separate command to produce confidence intervals for RMSEA using WLSMV. I conducted a CFA model using version 6 with WLMSV and it did not produce CIs for RMSEA. Thanks in advance! |
|
|
No, there is no option for this. |
|
|
I also had an editor ask for confidence intervals for RMSEA using WLSMV. I am using version 6. To confirm, there is no option to request CIs for RMSEA using WLSMV, correct? Thank you! |
|
|
It is available in the current version. |
|
|
Ok. I have to use TYPE=COMPLEX because I have a stratification variable. Is that why I'm not getting the confidence intervals for RMSEA with WLSMV? I do get CIs for RMSEA with TYPE=COMPLEX when indicators are continuous, just not categorical (WLSMV). Thank you very much for your help. |
|
|
You need Mplus 8.1 |
|
|
Ah, got it, makes sense. Thank you! |
|
Back to top |