Problem after multiple imputation PreviousNext
Mplus Discussion > Structural Equation Modeling >
 Eva Kingma posted on Monday, May 17, 2010 - 3:00 am
Dear Linda or Bengt,

I have a question. I runned a SEM model in Mplus on one data set. and as you can see below this model had a good fit.
After that I did multiple imputation in state and I runned the same SEM model on that 5 new datasets. However, now mplus cannot measure model fit and in the output it is stated that the number of free parameters is zero.
Do you have an idea what went wrong? If I gave you not enough information to answer my question, let me know please.

Best regards,



Chi-Square Test of Model Fit

Value 3.334
Degrees of Freedom 2
P-Value 0.1888

Chi-Square Test of Model Fit for the Baseline Model

Value 1974.023
Degrees of Freedom 27
P-Value 0.0000
 Linda K. Muthen posted on Monday, May 17, 2010 - 6:21 am
Please send the full output and your license number to
Back to top
Add Your Message Here
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Options: Enable HTML code in message
Automatically activate URLs in message