Cohort-sequential design with missing... PreviousNext
Mplus Discussion > Growth Modeling of Longitudinal Data >
 Daniel posted on Monday, November 08, 2004 - 11:29 am
I am being given a data set that includes approximately 12,000 individuals. There are two cohorts, however one cohort (N=4873) has two waves and the second cohort (N=8579) has three waves of data. More specifically, both cohorts have data at age 16. One cohort has data at age at the second wave. Both cohorts have data at the third wave. Thus, it is as if there were a single cohort (N=13452), with a third of individuals missing data at the second wave. The reviewers are asking for a longitudinal analysis, perhaps an LGM or LCGA? Do you have any recommendations for dealing with this data set? The dependednt variable is smoking (yes/no) at each wave. The independent variables are all binary (e.g., maternal smoking at baseline).
 bmuthen posted on Sunday, November 14, 2004 - 12:43 pm
You can do LGM or LCGA using either a single-group analysis allowing missing data as you indicate or using a 2-group analysis of the two cohorts, testing that they come from the same population. The former approach might be simpler here.
 Daniel Lee posted on Monday, August 24, 2015 - 7:20 am
Hi Dr. Muthen,

I am also using cohort sequential design to obtain age-based measurements to look at constructs across age 12 to 22...however, each individual was only observed 3 times. I tried to examine a quadratic trajectory, but Mplus would only allow linear. Just wanted to make sure that this was as it should be given that I have only 3 time points per case.


 Linda K. Muthen posted on Tuesday, August 25, 2015 - 7:12 am
You need at least four time points for a quadratic model.
 Jianhua Zhou posted on Saturday, June 16, 2018 - 1:48 am
Hi,Dr. Muthen,

I am working on a dataset with a cohort sequential design with grade 3,4,5 in primary school that are measured 4 times on the same variables biannually. Some outcome variables also measured 4 times.

Can I run a GMM and enter these outcome variables in such a cohort sequential design?

So thanks!
 Bengt O. Muthen posted on Saturday, June 16, 2018 - 3:25 pm
You can use the cohort approach of UG ex 6.18. Because you are using mixtures, you will have to replace Grouping with Knownclass. This means that you have one Knownclass "cg" latent class variable and one regular "c" latent class variable much like in UG ex8.8.
Back to top
Add Your Message Here
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Options: Enable HTML code in message
Automatically activate URLs in message