P Values Command PreviousNext
Mplus Discussion > Structural Equation Modeling >
 Luci M. posted on Friday, May 06, 2011 - 12:10 pm

What is the p value command? I read that if the Estimate/SE > 1.96 or - 1.96 the path coeff. significant.
But how do I get the actual p values?
I've seen the p values in some outputs in the internet but I don't have them in mine.

Thank you!
 Linda K. Muthen posted on Friday, May 06, 2011 - 2:35 pm
If you don't get p-values, you are using an older version. You would need to update to get p-values.
Back to top
Add Your Message Here
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Options: Enable HTML code in message
Automatically activate URLs in message