Decimals in output PreviousNext
Mplus Discussion > Structural Equation Modeling >
Message/Author
 Sung Joon Jang posted on Tuesday, June 09, 2015 - 12:58 pm
Mplus output generates coefficients with three digits after the decimal point. Is there a way that I can increase the number of digits? I have a coefficient that is significant, but it is .000 with SE of .000; which is awkward way to present significant results.
 Linda K. Muthen posted on Tuesday, June 09, 2015 - 1:27 pm
You can change the scale of the variables you are analyzing. We recommend keeping the variances of continuous variables between one and ten. You can use the DEFINE command to rescale by multiplying or dividing by a constant.
Back to top
Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: